Technical Support
- Peristaltic Pump >
- OEM Pump >
- Syringe Pump >
- Micro Piston Pump >
- Pump System >
- Other Pump >
Technical Articles
-
How to use External Control for WT600-1F
12/23/2016
Communication Control:The pump can connect to control computer (computer, PLC, SCM) through RS485 serial communication module (shown as below).
-
WT600-1F - Dispensing Peristaltic Pump Calibration
12/23/2016
Pump should be calibrated when flow rates or dispensing volume is out of the tolerance. Flow rates and dispensing volume can be calibrated separately in different applications.
-
WT600-1F - Peristaltic Pump Dispensing setting
12/23/2016
Before dispensing process, the parameters including pump head, tubing, back suction rpm, dispensing volume, copy number, flow rates, pause time, etc. must be set.
-
How to set back suction rpm for WT600-1F
12/23/2016
In dispensing and filling state, to prevent the liquids from dropping to cause error when the filling pauses, the pump will back-turn to suck back the liquids. The back turn angle is the same for each...
-
How to use Footswitch for WT600-1F
12/23/2016
Footswitch has two kinds of working modes.Trigger: Press footswitch, the pump starts running; Press footswitch again, the pump stops. Gated: The pump runs as long as the footswitch is pressed.
-
JL350-2J Large Flow Rates Pump External Control Function
12/23/2016
External analog signal controls the speed: The keys on the panel of frequency converter are invalid by setting the parameters (needs unlock). The speeds are controlled by external control terminals.48...
-
Basic operation of the Frequency Converter for JL350-2J
12/23/2016
The LED display of frequency converter lights when the power supply switches on. But the pump is in stopping status.Run /stop: Press [Run/Stop] key, the [Run] indicator lights and the pump runs. Press...
-
How to use Remote Control for Lead-2
12/23/2016
Communication Control:The pump can connect to control computer (computer, PLC, SCM) through RS485 serial communication module (shown as below).
-
How to use External Control Function for BT600-2J
12/23/2016
Analog Control Mode External control module is shown as below. When using external control function just trigger the External Control Switch in external control position and insert external control mo...
-
How to use External Control Function for BT300-2J
12/23/2016
Analog Control Mode:External control module is shown as below. When using external control function just trigger the External Control Switch in external control position and insert external control m...
-
Fahrenheit/Celsius Temperature Conversion Table
12/23/2016
Temperature Scales:The degree Fahrenheit (°F) is a unit of temperature named for the german physicist Gabriel Fahrenheit (1686 - 1736). In the Fahrenheit scale of temperature the freezing point of w...
-
How to use Remote Control for BT300-1F
12/16/2016
Communication Control The pump can connect to control computer (computer, PLC, SCM) through RS485 serial communication interface (shown as below). Analog Signal Input Function Set the “Remote Contro...